Suzuki 4x4 Club™

sj 413 · * Joined: 13 May 2008 Posts: 13 Location: norfolk

just brought me self a 1988 suzuki samurai sj 413 off ebay to put through an M.O.T and stuff for some fun and as me first car i will update you on this PROJECT as soon as im aloud to post some pictures !!
the only thing ive done to it so far is to remove the front driverside hub and wheel bearings as they desided to weld themselves to the hub and locking nuts ! so now on the hunt for wheel bearings, flange washer thingy and the two locking nuts and also i think there is ment to be a spacer aswell ?
wasnt on it or was melted ?
any help would be appreciated Very Happy

thanks jim

slight bit of rust to contend with !!

need new wheel bearing !! and lock nuts and tab washer !! anyone know were to get them from ?? zuki dealer ?

Google · Sponsor

sj 413 · * Joined: 13 May 2008 Posts: 13 Location: norfolk

hey
just wondering if anyone know were i could get the front drivers side spiggot and wheel bearing locking nuts or a complete front axel for my suzuki sj 413?
does anyone have a complete front axel kicking about ?? Smile

thanks
jim

mad · * Joined: 12 May 2008 Posts: 19 Location: kent

looks like your haveing fun with your moter Smile

hows it geting on Question

sj 413 · * Joined: 13 May 2008 Posts: 13 Location: norfolk

very slowly, but i have got all the parts to be getting on with (piston rings, gaskets, filters, wheel bearings, spiggot ! etc)
so should be running soon!! Very Happy

will keep you up to date.

mad · * Joined: 12 May 2008 Posts: 19 Location: kent

i thought i had a lot to do with my rotten vtaira Laughing

not looked at the engine and runing gear propely yet it is runing high on tick over nearly 2000 rpm and looks like the cluch needs replaceing hum think i may have got a bad one Embarassed

still will be good when all finished

sj 413 · * Joined: 13 May 2008 Posts: 13 Location: norfolk

brilliant!!! got some work to do:D join the crew, but its all good fun!
good luck mate

sj 413 · * Joined: 13 May 2008 Posts: 13 Location: norfolk

well over christmas and that i didnt do alot, apart form watch it rot on the drive way!, but now the days are drawing out more, ive been getting things going again, managed to get it back on four wheels, both diffs have been checked and bearings/ seals replaced, propshaftes free'd up, breaks re done and bled, gear box well it was like a soup ladle( was only a little bolt pin thingy just under the boot inside the jeep) brought some better seats(out of an escort) su carb fitted and tunned up! just need to get the body work sorted(patched up ) and throttle and choke cables sorted then i can get it MOT'd!!! soon be there !
thanks alot for the help and that, will get some recent photo's up here soon as im done Wink

thanks